PRODUCTS
EShop-number
Password
Welcome to SK Sales
 

ATCP4 • Automatic temperature fan speed controller

  • Automatic temperature fan speed controller
  • 230 Volts, 1 phase, 50Hz
  • Max. 4 Amps

Automatic temperature fan speed controller

Application

The ATCP4 is a low cost temperature controller that automatically adjusts the speed of the fan in relation to the difference between the temperature setpoint and the actual temperature.

Composition

  • The required temperature setpoint is selected using the dial on the controller and the fan will increase in speed (from the pre-set minimum speed) when the temperature rises above this setpoint.
  • The ATCP4 can be supplied with a bead temperature sensor on a flying lead or a wall mount sensor.

Technical Data

ModelSensor typeElectrical SupplyMax Rating
ATCP4-FLSFlying lead230v 1ph 50hz4 Amps
ATCP4-WMSWall mount230v 1ph 50hz4 Amps

Dimensions

ModelHeightWidthDepthMounting
ATCP4-FLS19714779Surface
ATCP4-WMS19714779Surface

Wiring diagram 1

Operation

Installation
1. Check that the controller supplied can safely control the size of the fans.
2. Remove front cover by unscrewing the fascia fi xing screws.
This provides access to mounting holes and electrical terminals
3. . Install in a dry sheltered position. Do not install in close proximity to a heat source.
4. All wiring and control equipment MUST comply with current applicable regulations,
in particular IEE552-01-02/03.
5. Earth connections to be made where applicable

Operation
The ATCP4 will automatically adjust the speed of the fan to maintain temperature setpoint

Temperature setpoint
Adjust the setpoint (Temperature you wish to maintain) using the graduated (-5...+45°C) dial on the fascia
P band (Pre-set and adjustment not normally required)
The P band is the degree of change in fan speed in relation to the change in temperature
If the P band requires adjusting this is done using Pre-set VR2

Minimum & Maximum pre-sets
The minimum and maximum fan speed can be adjusted using pre-sets VR3 & VR4 respectively

Sensor
The electrical supply to the sensor is a 12vdc isolated supply. The cable run to the sensor should not exceed 50 metres
Mobile WebsiteAbout UsDisclaimerPrivacy policyCookie policy

Requesting information. Please wait a moment...